This breakout board brings all 50 pins of its male dual row header out to screw terminal blocks for easy connection and prototyping work. Each pin is also brought to solder pads (3 per pin) at 0.1" spacing, allowing easy addition of single row or dual row pin headers. The solder pads are arranged in such a way that you can add an additional 2 x 25 header to the breakout board to bring all the signals back out on a ribbon cable if so desired (essentially forming a "T" connection). This break out board is perfect for experimentation and prototype work, as well as for use in the educational laboratory. It is well-suited for interfacing with I/O cards, data acquisition (DAQ) equipment, relay racks, Opto 22 racks, and any other device that uses a 2x25 50-position header connector. A dual row header is sometimes referred to as an "IDC Header", "IDC connector", or "ribbon cable connector". A breakout board is sometimes referred to as a "transition module", "terminal board", or "interface module".

Features

• 2 x 25 0.1" spaced male pin header
• Screw terminal for each data line
• Screw terminals accomodate wire sizes from 16AWG to 26AWG
• Solder connection holes, three (3) per pin
• Supports addition of .1" pin headers
• Ejector latches on header provide secure connection and quick disconnection
• Approximate dimensions: 3.0" x 4.5"
• Rubber feet