PISO-CAN-400-T Image
This image is representative of the product and may not be the exact image of this product.
Model: PISO-CAN-400-T
Manufacturer: ICP DAS
4 port Isolated Protection CAN Communication Board, 5 pin Screw Terminal Connector
Product Status: Active - Active products are produced on a regular manufacturing schedule and are actively supported products. Active products are not necessarily in stock in the USA. Lead time to ship date for Active products is typically stock to 15 business days ARO.

Stock Status: Call

Get Quote ->
The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN400/CAN200 can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector or 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN400/CAN200 uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.


  • Four independent CAN bus 2.0A/2.0B communication ports
  • Compatible with CAN specification 2.0 parts A and B
  • Connector:
    • 9-pin D-sub connector (PISO-CAN-400-D)
    • 5-pin screw terminal connector (PISO-CAN-400-T)
  • On-board optical isolation protection
  • Programmable transfer rate up to 1 Mbps
  • Jumper select 120Ω terminator resistor for each port
  • Direct memory mapping to the CAN controllers
  • 33MHz 32bit 5V PCI bus (V2.1) plug and play
  • PCI card, supports 5V PCI bus